The main reason to switch to our system is not only to increase reliability and use 209 primers, but to seal up the breech area and essentially eliminate all of the blow back issues. manual.This kit converts your Ruger 77/50 to allow the use of 209

Remington 700ML 209 Conversion Spare Nipple, XLA 13 1/2 - 27” Bipod – Pivot Model Black, T/C Encore .25 ACP Breech Plug Conversion, Remington 700ML Blackhorn 209 Conversion Kit, CVA Scope mount Dead On One-Piece Ring/Base System-Low, T/C Large Rifle Primer Breech Plug Conversion.

It’s just so similar it’s possible). 11 caps don't always provide enough fire to consistently ignite the powder charge, especially if you are using pellets. If you wanted to use 209 primers and the new Blackhorn 209 powder, this is Click here: To download Ruger

The conversion process requires the bolt to be completely stripped, our new firing pin to be installed, the extended shroud to be cut off, and the nose of the bolt dressed.

This Knight 209 Primer Ignition 50 Cal Muzzleloader Conversion Kit converts black powder guns shooting No. Sponsored by Dave Canterbury of Dirty Rotten Survival & Dual Survival This Adapter converts your 12 gauge Break Action Shotgun to be used as a muzzle loader. Winchester 209 Muzzleloader Primers Though they have the same exterior dimensions as a typical 209 shotshell primer, Winchester 209 muzzleloader primers are specifically designed for use in a muzzleloader. This kit converts your Ruger 77/50 to allow the use of 209 shotgun primers. The Ruger 77/50 209 Conversion Kit gives you the ability to fire those hotter 209 primers, virtually eliminating misfires and delayed ignitions.

our #1 Cleaner.

I’m not comfortable sending this one out for just anyone to install, and for now, will only offer it as a full conversion service. Without it, the unreliable, leaky rifle is not Blackhorn 209 compatible.

The kit contains a one-piece 209 nipple and breech plug, a new firing pin and a tool to help you remove your old firing pin and spring, a 209 de-capper and step by step instructions.

Then the 209 nose is timed to align it for loading and unloading, pressed on, and firing pin protrusion set. In order to develop and prove out a Badger Ridge sealed breech 77/50 209 conversion, a few 77/50’s were purchased and converted by Fred and myself. MUZZLELOADING BULLETS 580 695-4223 ray@bpbullets.com, Barnes Muzzleloader Bullets and Accessories, Precision Rifle Muzzleloading Accessories, Ruger 77/50 Muzzleloader 209 Conversion Kit. As always, Click here for additional information on the Ruger 77/50 209 conversion kit. Never MUZZLELOADING BULLETS 580 695-4223 ray@bpbullets.com, Barnes Muzzleloader Bullets and Accessories, Precision Rifle Muzzleloading Accessories, Ruger 77/50 Muzzleloader 209 Conversion Kit, Click here: To download Ruger Hot gasses and pieces of primers/caps being blown back and around the nipple and the associated fouling are generally referred to as “Blow Back”. At last, those hard to find Ruger 77/50 209 Conversion Kits are here. Never have the uncertainty of a misfire with a #11 cap! Conversion Kit $64.95

Everything is better with the Badger Ridge 209 kit. However the Ruger 77/50 is known to have an additional deficiency:  Blow-back launches the firing pin rearward and occasionally shears the trigger’s sear! (Not that we nor the manufacturer are endorsing that. consistently ignite the powder charge, especially if you are using pellets.

Which in my opinion is the best black powder substitute available. During wet weather, No. Mail us your bolt, we’ll convert, and send it back with the breech plug, vent liner, and other accessories. each click here to order.

The 77/50 uses a protrusion on the bolt itself to try and direct the blow-back to the side of the rifle. -no caps or hats. Before, you heard that typical pop then bang of your muzzleloader,

The Ruger 77/50 209 Conversion Kit gives you the ability to fire those hotter 209 primers, virtually eliminating misfires and delayed ignitions.

So once started, there really isn’t any going back. If you want the short answer, and you have a Remington 700 ML/MLS or a Ruger 77/50, the short answer is: buy our conversion kit, use full powered standard or magnum 209 shotgun primers and pair them with Sabots and Blackhorn209. davidkincaid, Aug 19, 2013 #1. pikid89 Member. And while on the surface it works similar to the Remington, and the breech plug threads of both are essentially identical, the 77/50 is a very different rifle to convert.

Having a couple of centerfire  Ruger 77 MKII’s that I’ve hunted with for years, in many ways it wasn’t a totally new rifle to me, even though it was a ‘totally new rifle’ to me.

Click graphic above to access owner's manual. Click graphic above to access owner's manual.This kit converts your Ruger 77/50 to allow the use of 209 shotgun primers. 209 muzzleloader to fire 209s.

Clean your muzzle loader thoroughly after shooting. I know from reloading shotshells that almost all 209 shotshell primers have varying outside diameters. The Ruger functioned very similar to the Remington 700 ML, and even had a breech thread that allowed use of 700ML breech plugs. reduce delays between the cap flash and powder ignition.